The Mean Well ELG-100-36A is a 100 W LED driver with a 36 V output and a 2.66 A limit, built for 36 V LED strip, bars and fittings. It runs constant voltage, switching to constant current from 18 to 36 V under full load, and the A model's built-in potentiometer lets you trim the output to suit your LEDs.
Set it to suit the load
The built-in potentiometer adjusts output voltage and current, so you can run LEDs a little below maximum for less heat and longer life, or fine-tune brightness across a run. It is the practical choice when you want a set-and-forget driver without a dimming system.
Built for real installations
Protection
- IP65 aluminium housing, rated for dry, damp and wet locations
- Short-circuit, over-voltage and over-temperature protection
- SELV Class 2 output
Input
- 100–305 VAC input
- Full 96 W on Australian 230–240 V mains
- Active power factor correction
Specifications
| Model | Mean Well ELG-100-36A |
| Output mode | Constant voltage + constant current |
| Rated output | 36 V DC, 2.66 A |
| Constant-current region | 18–36 V |
| Voltage adjustment | 32.4–39.6 V (potentiometer) |
| Rated power | 95.76 W (200–240 VAC input) |
| Input | 100–305 VAC |
| Dimming | None — output set by potentiometer |
| Ingress rating | IP65 |
| Dimensions | 199 × 63 × 35.5 mm |
| Leads | Bare input and output leads, no plug |
| Approvals | UL8750, CSA, ENEC, CB, CE |
Mean Well figures.
FAQ
Can I dim it with an AC Infinity controller?
No — the A model has no dim wires. For controller dimming choose a B or AB driver such as the HLG-120H-54B or HLG-320H-C2100AB.
How is this different from the LPF-60-36?
Both are 36 V. The ELG gives 100 W and an adjustment pot; the LPF-60-36 is 60 W, smaller, fully sealed to IP67 and fixed output.
How much LED strip will it run?
Up to 2.66 A at 36 V. Add up the wattage of your strip or fittings and stay at or under about 80–90% of 96 W for headroom.
Does it come with a plug?
No — bare leads, connected to mains by a licensed electrician.