The AC Infinity Grow Tent Gear Board is a steel mounting panel that stands against the inside wall of a grow tent and gives controllers, LED drivers, power boards and tools a proper home off the floor. The poles adjust from 91 to 152 cm (3–5 ft) to fit tents up to 152 × 152 cm (5 × 5 ft), the powder-coated frame holds up to 22.7 kg, and the mesh openings route cables out of the way. Genuine AC Infinity, stocked in Sydney and shipped domestically.
Vertical support system
A tent floor fills up fast: controller, LED driver, power board, timer, a humidifier cable, a pH pen. The gear board moves all of it onto the tent wall. Hook its legs over the base of the tent frame, extend the stabilising poles until they lock, and the panel stands at 82.7 cm high along the wall, leaving the floor clear for plants and making every device easy to see and reach.
The poles adjust so the board can sit clear of the duct ports rather than blocking them.
Cable management and mounting
The mesh has openings of different sizes, so plugs and cords pass through the panel and run behind it instead of across the floor. Devices mount the way that suits them: magnetic backing sticks straight to the steel, and screws, wire ties and hooks cover the rest. That suits AC Infinity controllers, LED drivers and ballasts, and clip fans alike.
Built for tent conditions
The frame is powder-coated steel, made to carry heavier devices and to sit in the warm, humid air of a flowering tent for the long term.
Specifications
| Product identification | |
| Manufacturer | AC Infinity Inc. |
| Product name | Grow Tent Gear Board |
| Model | AC-GBA3 |
| UPC | 819137024465 |
| Dimensions and performance | |
| Height | 82.7 cm (32.55 in) |
| Length | Adjustable 91–152 cm (3–5 ft) |
| Max tent fit | 152 × 152 cm (5 × 5 ft) |
| Weight capacity | 22.7 kg (50 lb) |
| Material | Powder-coated steel |
| Colour | Grey |
| Mounting | Magnetic backing, screws, wire ties, hooks |
| Documentation | |
| User manual | Gear Board manual (PDF) |
FAQ
Will it fit my tent?
It adjusts from 91 to 152 cm, so it fits tents from 3 ft (91 cm) up to 5 × 5 ft (152 × 152 cm) along one wall. In larger tents it still works; it just will not span the full wall.
Do I need tools to install it?
No. The legs hook over the tent base and the poles extend and lock by hand. Screws are only needed if you choose to screw a device to the panel.
Will it block my duct ports?
No. Adjust the poles so the panel sits clear of the ports.
Can it take an LED driver?
Yes. LED drivers, controllers, power boards and similar devices are what it is built for, up to 22.7 kg in total.